GM TBI FUEL PUMP AND HANGER ASSEMBLY
110 LPH Electric Fuel Pump Assembly for Sniper EFI Fuel Tanks using GM stock TBI injection. Oven brazed fittings can withstand 100 psi. Genuine Walbro Fuel Pump included. 1/4" NPT Supply and Return line.Features:
- 1/4" NPT Supply and Return Line
- In-Tank Wire Harness
- Made in USA
- Heavy 10 gauge no-warp mounting plate
- Barbed Vent Fittings
Head Gasket Shellac Compound or
Aviation Form-A-Gasket sealant on the
gasket and screws.
Connect your in-tank wire harness to the fuel pump, making sure that the connections are secure. Route the wires through the pass through fitting being sure to leave a little slack to prevent strain or chaffing, Use a 9mm wrench to tighten the upper jam nut on the wire pass through in 1/4 turn increments until the wire no longer moves up and down. BE CAREFULL NOT TO OVERTIGHTEN DOING SO COULD BREAK THE FITTING OR CAUSE A LEAK.
- Item Requires Shipping
- W4.0000” x H4.0000” x L15.0000”
- Free Ground Shipping, lower 48 states ( some exclusions may apply)
Total Reviews (0)
Write the First Review!
You must login to post a review.