Holley Sniper EFI
Click on image to zoom

19-168 400 LPH Fuel Pump Assembly & Hanger

(0) Reviews: Write first review
19-168
Replacement 400 LPH FUEL PUMP AND HANGER ASSEMBLY
Pricing: $393.95
Qty:
Free Ground Shipping, lower 48 states ( some exclusions may apply)

Description

400 LPH Electric Fuel Pump Assembly for Sniper EFI Fuel Tanks. Oven brazed fittings can withstand 100 psi. Genuine Walbro Fuel Pump included.

1/4" NPT Supply and Return line.

For a better seal use Permatex Indian

Head Gasket Shellac Compound or

Aviation Form-A-Gasket sealant on the

gasket and screws.

Features:
  • 1/4" NPT Supply and Return Line
  • In-Tank Wire Harness
  • Made in USA
  • Heavy 10 gauge no-warp mounting plate
  • Barbed Vent Fittings
  • Up to 100 PSI
  • New Mounting Screws and gasket available separately

Installation Notes

New Mounting Screws and gasket available separately.
*19-170 kit is a thicker gasket and longer screws for use on the GM A Body (Chevelle, GTO, etc....) fuel tanks since they are shallower at the point where the fuel pump is mounted.
*19-169 kit for all other EFI fuel tanks
Connect your in-tank wire harness to the fuel pump, making sure that the connections are secure. Route the wires through the pass through fitting being sure to leave a little slack to prevent strain or chaffing, Use a 9mm wrench to tighten the upper jam nut on the wire pass through in 1/4 turn increments until the wire no longer moves up and down. BE CAREFULL NOT TO OVERTIGHTEN DOING SO COULD BREAK THE FITTING OR CAUSE A LEAK.

Details

Categories

Shipping Information

  • Item Requires Shipping
  • W4.0000” x H4.0000” x L15.0000”
  • Free Ground Shipping, lower 48 states ( some exclusions may apply)

Customer Reviews

Comment Total Reviews (0)

Write the First Review!

You must login to post a review.