Holley Sniper EFI 400 LPH Fuel Pump & Hanger Assembly - Replacement

400 LPH Electric Fuel Pump Assembly for Sniper EFI Fuel Tanks. Oven brazed fittings can withstand 100 psi. Genuine Walbro Fuel Pump included. 1/4" NPT Supply and Return line. For a better seal, use Permatex Indian Head Gasket Shellac Compound or Aviation Form-A-Gasket sealant on the gasket and screws.

Features

• 1/4" NPT Supply and Return Line
• In-Tank Wire Harness
• Made in USA
• Heavy 10 gauge no-warp mounting plate
• Barbed Vent Fittings
• Up to 100 PSI
• New Mounting Screws and gasket available separately

Notes

• New Mounting Screws and gasket available separately.
• 19-170 kit is a thicker gasket and longer screws for use on the GM A Body (Chevelle, GTO, etc...) fuel tanks since they are shallower at the point where the fuel pump is mounted.
• 19-169 kit for all other EFI fuel tanks
• Connect your in-tank wire harness to the fuel pump, making sure that the connections are secure. Route the wires through the pass through fitting being sure to leave a little slack to prevent strain or chaffing, Use a 9mm wrench to tighten the upper jam nut on the wire pass through in 1/4 turn increments until the wire no longer moves up and down. BE CAREFULL NOT TO OVERTIGHTEN DOING SO COULD BREAK THE FITTING OR CAUSE A LEAK.